當前位置：四川川大干燥科技工程有限責任公司>>烘干類Drying equipment>>烘缸滾刮干燥機Continuously scraping drier with a drying c

烘缸滾刮干燥機Continuously scraping drier with a drying c

返回列表頁

參考價

面議

具體成交價以合同協議為準

產品型號

品牌

廠商性質其他

所在地成都市

在線詢價 收藏產品查看聯系電話

包裝印刷網采購部電話：0571-88918531QQ:2568841715

聯系方式：查看聯系方式

更新時間：2024-11-14 14:01:24瀏覽次數：109次

聯系我時，請告知來自包裝印刷網

產品分類 品牌分類

  烘干類Drying equipment

全部產品列表

暫無信息

四川川大干燥科技工程有限責任公司

經營模式：其他

商鋪產品：2條

所在地區：

詢價 給他留言

產品簡介

詳細介紹

一、工作原理及應用范圍介紹 Introduction of Working Principle and Scope of Application

無縫承壓型鋼管經加工組合成單個或多個烘缸，滾筒烘缸在傳動系統帶動下作回轉運動，熱源通入烘缸內壁，筒體外壁部分浸入需干燥的料漿中，使一層物料均布于烘缸外表而被加熱，水被氣化帶走。滾筒轉動一周而物料就完成了干燥過程且結于烘缸表面，然后被刮刀卸下從而完成干燥卸料的過程。

本機廣泛應用于高粘度、高濃度漿料的烘干，如：酵母泥、聚合氯化鋁（凈水劑）、糊精、尾渣、魚蝦飼料等。

Seamless pressurized steel pipes are processed into single drying cylinder or multiple drying cylinders, and the drum drying cylinder is driven by the drive system to conduct a rotary motion, heat source enters into the inner wall of drying cylinder, and outer wall of drum is immersed into the slurry that has been dried, to make a layer of materials be evenly distributed on the outer surface of drying cylinder and heated, thus the moisture is taken away by vaporization. After the rotary drum rotates one cycle, the materials complete its drying process and solidify on the surface of drying cylinder, and then the materials are removed by the scraper to complete the process of drying and discharging.

The drying machine is widely used for drying of slurry with high viscosity and concentration, such as yeast paste, aluminium polychlorid (purifier), dextrin, tailings and fish and shrimp feed.

二、特點Characteristics

1.連續操作、質量穩定、節省勞動力，能夠得到均勻的產品。

2.干燥時間短，一般約為7-30s，干燥產品沒有受高溫的危險，適合于熱敏性物料的干燥。

3.適應料漿黏度范圍廣。

4.熱效率高，可達70％-80％。

5.因干燥器內不會殘留產品，少量物料也可干燥。

6.操作參數調整范圍廣，并易于調整。

7.機內易于清理，改變用途容易。

8.尾氣不帶走物料，不需除塵設備。

9.設備操作彈性較大，易于控制調節。

10.該機可用于環保行業的廢液處理。

11.干燥速率大，筒壁上濕料膜的傳熱傳質過程由里向外，方向一致，溫度梯度較大，使料膜表面保持較高的蒸發強度。

1. Continuous operation, stable quality, labor-saving and able to obtain uniform products.

2. It has a short drying time, generally about 7-30s. It will not make the products to be dried suffer the risk of high temperature and it is suitable for drying of heat sensitive materials.

3. Wide adaption range for slurry viscosity.

4. High thermal efficiency of 70％-80％.

5. Without residuary product in the drier, a small amount of materials can also be dried.

6. Operation parameters have a wide adjustment range and are easy for adjustment.

7. It is easy to clean the machine as well as change the use.

8. End gas doesn’t carry off materials and dust remover is not required.

9. With large equipment operating flexibility, it is easy for control and adjustment.

10.The machine can be used for liquid waste disposal in the environmental industry.

11.It has high drying speed, the heat and mass transfer process of wet materials membrane on the cylinder wall is from inside to outside in the same direction and with relatively large temperature gradient, to make the surface of materials cylinder wall keep a relatively high evaporation intensity.

三、技術參數（下表中數值僅供選型時參考）

Technical parameters (the values in the table below are for reference in type selection only)