包裝印刷網>產品庫>儀器儀表>其它儀器儀表>其它>>HH-TEG 三甘醇分析專用填充柱

HH-TEG 三甘醇分析專用填充柱

參考價	面議

參考價

面議

具體成交價以合同協議為準

公司名稱浩瀚色譜（山東）應用技術開發有限公司
品牌
型號HH-TEG
所在地滕州市
廠商性質其他
更新時間2026/9/28 11:26:52
訪問次數12

產品標簽:

在線詢價收藏產品點擊查看電話

索取相關資料

公司介紹主營產品

浩瀚色譜（山東）應用技術開發有限公司,是齊魯大地一家從事色譜儀器技術開發，技術推廣的技術型企業，研發出多款新型產品。（一）專用色譜柱：1.氯乙suan直接進樣分析專用柱2.直接進樣分析專用柱3.氯QI直接進樣分析專用柱4.四氟化硅直接進樣分析專用柱5.六氟二甲基硅醚分析專用柱6.氨氣直接進樣分析專用柱（二）痕量分析專用氣相色譜儀：1.高純氣體中痕量水（ppb級）分析專用氣相色譜儀2.純苯中痕量噻吩（ppb級）分析專用氣相色譜儀（三）防腐型氣相色譜儀，并成功應用于氟氣，*，氯QI，氨氣，酰氯，，三氯氫硅，四氟化硅，氯YI酸，氯HUA亞砜，硫化物，二氯化硫等腐蝕性物質檢測，產品遍布各個行業及地區，其中不乏有大型央企---中石油，中儲糧，秦山核電站，中紡集團等，部分出口。公司主要業務1.通用氣相色譜儀生產銷售：氫火焰檢測器氣相色譜儀，熱導檢測器氣相色譜儀，火焰光度檢測器氣相色譜儀，氮磷檢測器氣相色譜儀，電子捕獲檢測器氣相色譜儀。2.便攜式氣相色譜儀，在線氣相色譜儀生產銷售。3.專用氣相色譜儀研發制造：氧化鋯檢測器氣相色譜儀，氦離子檢測器氣相色譜儀，氬離子檢測器氣相色譜儀等。4.防腐氣相色譜儀5.二維，多維氣相色譜儀6.高效液相色譜儀7.實驗室純水機，頂空進樣器，自動進樣器，熱解析儀，氮?dú)淇瞻l(fā)生器，色譜耗材（色譜柱，石墨墊，穩壓閥，壓蓋鉗，頂空瓶，7725進樣閥等），分光光度計，電子天平，水分測定儀，干燥箱，離心機，玻璃儀器，化學試劑等整套實驗室設備生產銷售。8.提供技術轉讓，建立分析方法。9.從事舊色譜以舊換新的業務。10.色譜柱研制，定做。11.承接樣品的檢測業務。12.承接國內外色譜儀器的維修，改裝業務。浩瀚色譜（山東）應用技術開發有限公司，以客戶為中心，想客戶所想，銷售的不僅僅是產品，重要的是幫助客戶解決問題，架起心靈溝通的橋梁。

展開顯示更多內容

熱導氣相色譜儀

產品簡介在線詢價

三甘醇分析專用填充柱，室內空氣，焦?fàn)t煤氣，煉廠氣，天然氣，變壓器油，多氯聯苯，植物油，6號溶劑殘留，頂空進樣器，消毒劑，芝麻香白酒，3-甲硫基丙醇，植物油，6號溶劑殘留

HH-TEG 三甘醇分析專用填充柱產品信息

三甘醇分析專用填充柱
三甘醇分析專用填充柱詳細信息：

規格：1m*3mm
型號：HH-TEG

二縮三乙二醇俗名三甘醇是有機的重要原料。容量分析采用吡啶催化的乙酰化,該法分析一個樣品所需時間較長,且分析結果很不理想。而采用氣相色譜分析的方法能克服這些缺點。

滕州市浩瀚色譜儀器技術服務有限公司，與時俱進，以科學發展觀為指導，研發出專用填充柱，成功測定了三甘醇中二甘醇，乙二醇的含量，結果滿意。

三甘醇分析專用填充柱測定譜圖：

Quality assurance:

Use high-quality stainless steel tubes, glass tubes and chromatographic packing to make various packed chromatographic columns

If you need to use stainless steel filter screen as the plug at both ends of the column, please specify when ordering

If on-column injection is used, there will be a space of 6CM in front of the column inlet,

To prevent the chromatographic packing from flowing out, both ends of the column are blocked with silanized glass wool

If a chromatographic column with valve injection or non-on-column injection is used, the column inlet is filled

Available in various types of glass column configurations for gas chromatographs

The entrance of the 2mm inner diameter glass column tube is equipped with a slope to facilitate sample injection

Each chromatographic column has been fully aging and strict quality evaluation test

Precautions

Thank you for purchasing the column produced by Haohan.

Each chromatographic column provided by Haohan has been aged. To ensure the analytical separation effect you obtain, please aged for 1-2 hours before use. When aging, the carrier gas should be ventilated for about 10 minutes, and after the air in the column is cleaned up, use the program to increase the temperature to the highest use temperature for aging.

To avoid contamination of the detector, please do not connect the column to the detector during aging.

When the temperature of the column oven is higher than room temperature, a small amount of oxygen in the carrier gas will damage the stationary phase in the chromatographic column. The carrier gas must be further deoxidized by a deoxidizing tube (it is recommended that the oxygen content in the carrier gas used should not exceed 1PPm)

When installing the chromatographic column, the product brａnd should face the operator, and the injection port of the chromatographic column (or see label) on the left.

When disassembling the column, first lower the column temperature to room temperature, and then turn off the carrier gas.

Precautions

Thank you for purchasing the column produced by Haohan.

Each chromatographic column provided by Haohan has been aged. To ensure the analytical separation effect you obtain, please aged for 1-2 hours before use. When aging, the carrier gas should be ventilated for about 10 minutes, and after the air in the column is cleaned up, use the program to increase the temperature to the highest use temperature for aging.

To avoid contamination of the detector, please do not connect the column to the detector during aging.

When the temperature of the column oven is higher than room temperature, a small amount of oxygen in the carrier gas will damage the stationary phase in the chromatographic column. The carrier gas must be further deoxidized by a deoxidizing tube (it is recommended that the oxygen content in the carrier gas used should not exceed 1PPm)

When installing the chromatographic column, the product brａnd should face the operator, and the injection port of the chromatographic column (or see label) on the left.

When disassembling the column, first lower the column temperature to room temperature, and then turn off the carrier gas.